Slicer Discord
USB flash drive cryptex + 4 micro sd – 3D-Druckmodell von Thingiverse Thingiverse
USB flash drive cryptex + 4 micro sd – Bild 1 USB flash drive cryptex + 4 micro sd – Bild 2 USB flash drive cryptex + 4 micro sd – Bild 3 USB flash drive cryptex + 4 micro sd – Bild 4 USB flash drive cryptex + 4 micro sd – Bild 5 USB flash drive cryptex + 4 micro sd – Bild 6
Toys & Games

USB flash drive cryptex + 4 micro sd

1.1k Downloads
866 Likes
9 Makes
Zum Modell
remix from USB Flash Drive Variable Cryptex
by rwsmith123

80 mm long
36 mm wide over all
can make and use your own combo by slipping the rings off
then back on to the inner rings

added 4 micro sd card slots to the usb hole.
added my own parts tray so u can swap and go
or add cash toys etc.

tight fit need to clean edges and slide in and out few times.
green arrow shows where u might need to trim to get end cap on
Kategorie
Toys & Games
Quelle
Thingiverse
Veröffentlicht
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen