USB Hub SSD Rack

I was looking for a rack for my varied external SSD drives and ran across this one. https://makerworld.com/en/models/1070429#profileId-1060204. I printed in PETG as that was what I had loaded, and it works well. But I needed a USB Hub to connect and decided on this one from Amazon. https://www.amazon.com/dp/B00SCX6I8A?ref=ppx_yo2ov_dt_b_fed_asin_titleIt has 7 ports and 2 for charging on the end. Then I had to figure out how to organize. So I remixed the above model's vertical stand to 80mm clearance and added two holes to use 3mm screws to hold the tray for the Hub together. Printed two and the tray and then assembled. Slide everything together, and then used a long zip tie to keep the hub in place. All neat and organized. Hope it helps some of you.