Thingiverse
USB-Memory chip tray
door bitzoid
2
Downloads
1
Likes
0
Makes
This is a tray I made for housing the memory+plug unit from a USB-drive. The drive in question is 11mm wide and 16 mm long and fits just in the front compartment. These values can be adjusted in the scad file. The entire assembly is 1.5mm high.
If a small spring is placed between the two parts in the print, it will push the plug part out of whatever housing you put this into.
If a small spring is placed between the two parts in the print, it will push the plug part out of whatever housing you put this into.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
