USB port cleaning tool

All USB ports get dirt in them, and this can build up over time. It can be difficult to find something thin and strong enough to be able to go inside the port and pull out all the dirt and fluff that is in there. While many of us have paperclips that would work, you mustn't use a paperclip as it is metal and conducts electricity! The body of this cleaning tool is just long and thick enough to be able to get a good grip with your finger and thumb, with little wasted space.Both the top point and bottom hook are just long enough to be able to go into the port at different angles. I have set the layer height to be 0.08mm as this allows 6 layers of filament. The more layers, the stronger it will be, but it needs to be very thin to not get stuck inside the USB port.Uses only 0.51g of filament Takes 6m 28s to print (on the H2D) which is quicker than the preparation time! I have set Ironing on the top surfaces to make it a little smoother, this can be removed if you want it to print 50 sec