Thingiverse
USB Power Blocker Case
di fatmann66
1
Download
0
Likes
0
Makes
This is a simple case for USB power blocker for 3D printers, OctoPrint, or Raspberry Pi.
Found here: https://www.tindie.com/products/fatmannmakes/usb-power-blocker-inhibitor/
The alignment pins are very small, but I never had an issue printing them. Put a few drops of CA glue on the corners to seal.
Optionally can use some hot glue on both sides of the board.
Found here: https://www.tindie.com/products/fatmannmakes/usb-power-blocker-inhibitor/
The alignment pins are very small, but I never had an issue printing them. Put a few drops of CA glue on the corners to seal.
Optionally can use some hot glue on both sides of the board.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
