Thingiverse
USB powered LED WIFI Clock (8USD)
von Zer0s
2
Downloads
3
Likes
0
Makes
Update 28 Feb 2023: Saw a better deal and updated the affiliate link.
*****
Finally found a low cost USB powered LED clock that will sync time off the internet via Wi-Fi! But didn't have a case/holder.
So I designed a simple snap on holder to tilt it 15 degrees and make it more stable.
Please read through description below about the Wi-Fi clock before proceeding to print.
Firmware on the clock is for time zone GMT+8 hours, if you like a different time zone, you will need to flash a different firmware. I have not tried that as the current time zone is perfect for me.
I find the original firmware has a security flaw as anyone can assess it through the Wi-Fi SSID and know your home Wi-Fi password. My workaround is to put some conductive tape over the Wi-Fi antenna to weaken the Wi-Fi signal. In its original state, the signal strength is already quite weak but will likely still penetrate through one wall.
Firmware available on Github. (Proceed at own risk)
https://gi
*****
Finally found a low cost USB powered LED clock that will sync time off the internet via Wi-Fi! But didn't have a case/holder.
So I designed a simple snap on holder to tilt it 15 degrees and make it more stable.
Please read through description below about the Wi-Fi clock before proceeding to print.
Firmware on the clock is for time zone GMT+8 hours, if you like a different time zone, you will need to flash a different firmware. I have not tried that as the current time zone is perfect for me.
I find the original firmware has a security flaw as anyone can assess it through the Wi-Fi SSID and know your home Wi-Fi password. My workaround is to put some conductive tape over the Wi-Fi antenna to weaken the Wi-Fi signal. In its original state, the signal strength is already quite weak but will likely still penetrate through one wall.
Firmware available on Github. (Proceed at own risk)
https://gi
Zer0s veröffentlicht auch auf
111 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!