MakerWorld
Electronics
Ver Modelo
USB step converter case
64
Descargas
27
Likes
42
Makes
This is my design of a simple friction fit case for a dcdc usb step up down converter from amazon. To extend the button through the case, you just need a small piece of filament wich you melt with a lighter on one end and flatten it on the table. Then you insert it from inside of the case. After that you shorten it and flatten it again with a lighter on the other side. (take a look at the pictures)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
