Thingiverse
USB Support for CR-10/s Controller
von AbdullahAlMarar
0
Downloads
0
Likes
0
Makes
Because the USB cable on my CR-10s's control box would get loose and disconnected, I made a simple support holder which works really well, so I wanted to share it.
It needed a bit of sanding to fit my USB cable, so I edited the design after printing.
The dimensions of the hole are
1.17cm (h) by 1.11cm (w)
The Fusion360 file is included for your own fit if needed.
It needed a bit of sanding to fit my USB cable, so I edited the design after printing.
The dimensions of the hole are
1.17cm (h) by 1.11cm (w)
The Fusion360 file is included for your own fit if needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!