USB Thumb drive holder

*Overview*

Decorative container for a small USB flash drive.

There is space for a USB cord to your computer or device.


*Settings*

Layer height: 0.2

Infill: 15%

Supports: Yes

Support on base plate only: Yes


*Files and Post-print cleanup, Assembly*

For the USB cable I used a standard USB C to USB Female cable.

1. PartA.stl is the base of the unit, including decorative terrain.

You'll have to remove the supports only from the wire channel portion on the bottom.

2. PartB.stl is the cap and should print much quicker.

This should already be rotated appropriately for printing, intended for supports under the dome of the cap.

If the flash drive is too long you may have to use it without the enclosing cap.

The base or canister is designed so that the USB Female end of the cord should entirely fit, with some space left over for the actual flash drive. There is some room in the base for the cable to curve, from vertical to horizontal.


*Software*

I used a Python file to help dr