USB Type B wall mount

I made this USB type B holder because I wanted to extend my Arduino port onto the enclosure of my printer after I made a casing for it, to print ABS better and I wanted to make everything look as nice as possible from the outside. Feel free to use it for whatever projects you may like, it has 4 mm holes and M4 nut holder for easy installation. After I installed the connector, I covered it with hot glue but it's not mandatory, my setup is permanent.

You would need a piece of 20x20 mm prototyping board, one USB Type B female PCB mount connector, one USB Type B male cable with an ending without connector. I cut my cable that came with the printer, it was very short anyway.

Or you can just buy one... https://de.aliexpress.com/store/product/Brand-New-High-Quality-USB-2-0-A-Male-to-USB-A-Female-Panel-Mount-Extension/1494743_32785594584.html

USB Type B female connector - goo.gl/OH6yZO