Thingiverse
USBasp dongle case
door Ratunkow
2
Downloads
0
Likes
0
Makes
Case for the USBasp board (black) in two parts.
The holes in the housing for the LEDs are sealed with transparent epoxy.
The case is glued together and the programmer is inserted into the case.
I also separated by cutting the conductive tracks from GND, and brought out the wires of the 5V - 3.3V switch jumper into two tracks (the cut points are marked with red lines).
I made two types of wires, one has a jumper in the 10-pin connector - for 5V and a cable without a jumper for programming chips with a supply voltage of 3.3 volts
The holes in the housing for the LEDs are sealed with transparent epoxy.
The case is glued together and the programmer is inserted into the case.
I also separated by cutting the conductive tracks from GND, and brought out the wires of the 5V - 3.3V switch jumper into two tracks (the cut points are marked with red lines).
I made two types of wires, one has a jumper in the 10-pin connector - for 5V and a cable without a jumper for programming chips with a supply voltage of 3.3 volts
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
