Thingiverse
USBtin D-SUB case
door theflope
2
Downloads
4
Likes
0
Makes
This is a case for the USBtin (https://www.fischl.de/usbtin/) CAN bus USB adapter.
The design is intended to protect the PCB and at de same time adapt to the widely used D-SUB connector.
The lid should click in place nicely but is not intended to be totally tight.
I used two M2*4 self tapping screws to fix the PCB in place. For the D-SUB connection you will need a standard panel mount female d-sub connector socket and matching mounting bolts.
Then just solder the CAN wires to the D-SUB interface and use the screw terminals to connect to the USBtin.
The design is intended to protect the PCB and at de same time adapt to the widely used D-SUB connector.
The lid should click in place nicely but is not intended to be totally tight.
I used two M2*4 self tapping screws to fix the PCB in place. For the D-SUB connection you will need a standard panel mount female d-sub connector socket and matching mounting bolts.
Then just solder the CAN wires to the D-SUB interface and use the screw terminals to connect to the USBtin.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
