Thingiverse
USBtinyISP-Clone Case
by blkhawk
6
Downloads
4
Likes
0
Makes
This is a case for a common USBTinyISP clone. I wanted something that was as small as sensibly possible and allows for access to the headers as well as the 5V power jumper. The LEDs had to be visible as well.
You need 4 M3 screws of about 10-12mm in length to close the case up. I added a picture of the type of board so you can check if it fits. I also included the openScad files in case ou need to adjust things a bit.
You need 4 M3 screws of about 10-12mm in length to close the case up. I added a picture of the type of board so you can check if it fits. I also included the openScad files in case ou need to adjust things a bit.
blkhawk also publishes on
18 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
