Useless box

Creation of a detailed video explaining how to assemble is in progress.Printed in PLA Important Notes: Depending on the exact model of MG995 servo you order, you might need to cut the servo sockets a little (the 3d printed plastic) so that the motor connector will stick out enough from the other side.If the servo gear is below the surface of the wall, you probably need to trim the sockets a little bit.Notice the position of the micro switch.These screws might hit their adjacent wall, I will work on an improved model where this doesnt happen.For now you can either let them grind or glue the servo mount with epoxy glue, instead of using the screwsMake sure the starting position of the arm is pressing the microswitch down. if it's not enough bend gently the microswitch lever to increase pressure. if the servo will try to force its way because it is not calibrated properly it might “eat” the plastic gears. a good improvement (slightly more expensive) is to use full metal gears servo.So