Utah State Flag

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmYou may print at higher layer heights below the Base Thickness of 0.48mmThe Max allowed Thickness is 2.24mm and the Actual Thickness is 1.68mmFilaments Used: PLA BambuLab Basic Blue Transmission Distance: 4 PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Yellow Transmission Distance: 6 PLA BambuLab Basic Jade White Transmission Distance: 5This print uses 4 unique filamentsSwap Instructions: Start with Blue At layer #6 (0.56mm) swap to Red At layer #9 (0.8mm) swap to Yellow At layer #15 (1.28mm) swap to Jade White for the rest.