Utensil drainer

For a while, I was looking for something that could drain the water after the cleaning of the ustensils without having to be on the edge of the sink. Whith this one, you can put it where you want without buthering about water spillage. Since there is not much water coming out of the tray, the recuperator bin is almost too big, since after a couple hours the water evaporates anyway. I made it so there is no need for supports, but you will have to glue the base to the leg stand. The leg that goes in the recuperator bin is 3mm shorter so everything is level when assembled.
There is a slope on the main compartment to drain the water.
The idea was to make it in detachable parts to make it easy to clean it. While printing the square part, something went wrong, and i had to redo the upper part that's why you can see a line of epoxy.
I only printed one unit, and i use it everyday.