Utility Knife Prototype V2 (w/Bearing)

the design is not perfect
i do not have a proper way to print the "bladeholder.stl" so i paused it and imprinted the blade into it.

i soon will rework the "bladeholder.stl" into two pieces to make it easier to print and switch the blades.

there also will be a compartment for 2 extra blades you can carry with you.

___________________________________________________________________
COMING SOON:

608 bearing conversion (you could actually try printing some bearings)
cable/bowden tube cutting helpers (2-8mm? leave a comment)
___________________________________________________________________

the knife sits tight when closed but theres no locking mechanism when its open!
its right for my purpose but may not be for yours

if you have any suggestions, leave a comment :)

Bearing Dimensions: 14mmID x 26mmOD x 10mmW
The Holding pin is 13.7mmOD