Thingiverse
UV Curing Chamber
von j0ckinjz
3
Downloads
5
Likes
1
Makes
Buy one of those lights & turntables from amazon and install into this. I bought https://www.amazon.com/dp/B083ZFH24H/
Glue/Weld the two chamber pieces together. Use 1.75 filament for hinge.
I'm still in the process of printing/building this so pics to come.
Chamber prints in 4 pieces. Top, Bottom, Door, and Light Fixture.
Chamber is 250mm high. Turntable shouldn't take up more than ~45mm which leaves a bit more than 200mm of height space. Diameter is 150mm. Door is 130mm wide. Should fit most parts printable on a base SLA printer.
Pieces are not oriented correctly because I still haven't learned how to design on the correct plane... Should be easy to figure out the best orientation.
Glue/Weld the two chamber pieces together. Use 1.75 filament for hinge.
I'm still in the process of printing/building this so pics to come.
Chamber prints in 4 pieces. Top, Bottom, Door, and Light Fixture.
Chamber is 250mm high. Turntable shouldn't take up more than ~45mm which leaves a bit more than 200mm of height space. Diameter is 150mm. Door is 130mm wide. Should fit most parts printable on a base SLA printer.
Pieces are not oriented correctly because I still haven't learned how to design on the correct plane... Should be easy to figure out the best orientation.
j0ckinjz veröffentlicht auch auf
21 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
