Thingiverse
V0.1_Z-alignment_jig
by Kapplion
60
Downloads
33
Likes
1
Makes
This jig is for aligning the beams wich hold the z-rails of the Voron V0.1.
On page 25 of the assembly manual (state 16.06.2021 https://raw.githubusercontent.com/VoronDesign/Voron-0/Voron0.1/Manuals/Assembly_Manual_0.1.pdf) you have to possition the right beam 58mm from the left side wich this jig is for.
On page 25 of the assembly manual (state 16.06.2021 https://raw.githubusercontent.com/VoronDesign/Voron-0/Voron0.1/Manuals/Assembly_Manual_0.1.pdf) you have to possition the right beam 58mm from the left side wich this jig is for.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
