Thingiverse
Vactrol housing
por pnoreck
34
Descargas
31
Likes
1
Makes
This is a DIY vactrol housing for a LED and a LDR. With PLA it's a little bit lose but it makes space for a drop of superglue.
Print the open side facing up.
The LDR goes into the tube and the LED into the outer part. After that you can slide the tube into the housing. Print time around 15 till 20 minutes.
Print the open side facing up.
The LDR goes into the tube and the LED into the outer part. After that you can slide the tube into the housing. Print time around 15 till 20 minutes.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
