Vacuum Pack nozzle

I wanted a way to easily use my shop vac to help vacuum seal my filaments. I have a Dewalt ShopVac that would do well, just needed to reduce the suction/ control the suction. by adding holes in the pipe going to the end of the vacuum I was able to control the amount of suction allowing me to remove the nozzle without being tangled in the ziploc. To make this I took the linked model, scaled it to my size using calipers and added negative cylinders to the design allowing for holes on both sides. Then I exported it as a single mesh. I printed with the following settings:Material: Generic PETGWalls: 3 wallsInfill Percentage: 25%Infill Type: Adaptive CubicLayer Height .2mmNo supports