Vacuum Table for CNC Machine

This is a 2ft. x 2ft. vacuum table designed for a CNCRouterparts "Benchtop Pro" CNC Router machine.

Process (in a nutshell):
1. Obtain your MDF wood
2. Load the file in Fusion 360 (free for hobbyists)
3. Select/create your tool and regenerate tool-paths (Note: this could take a while. Fusion 360 just does not like this tool path. My computer uses up to 5GB RAM and 5-10 minutes to make any changes to the main air chamber tool path. )
4. Process output files (keep operations separate)
5. Load the file into Mach3 (licensed)
6. Set your "zero" for X and Y but follow the NOTICE below for setting your Z-zero
7. Run operation to cut main chamber
8. Run operation to cut vacuum port
9. Flip material, re-zero
10. Run operation to cut "guide holes" - these holes are not through the material
11. Assemble using duct tape and shop vac
12. Fasten to work table
13. Selectively drill out holes for your media size using a cordless drill and drill bit
14. Enjoy!

NOTICE: You must cut t