Valentines Day Vault

This is the Valentines Day Heart Vault.No supports, hardware or glue is required and it's a very quick print (Less than 1 ½ hours on an X1C). It has a print-in place lock and an optional top that has in integrated key. INSTRUCTIONS: (Steps 1 and 2 must be done with the key, not the optional top with integrated key) After printing, Insert the the key FULLY into the keyhole and GENTLY rotate it back and forth until the locking cylinder breaks free and spins. (Hold the key as close to the model as possible and be gentle, so as not to snap the key off).If you print the optional top with integrated key, you may need to break that rotating piece free as well - grasping the key protrusion or the handle side GENTLY rotate it back and forth the break it free. DONT FORCE EITHER TOO HARD OR THE KEY SHAFT MAY SNAP OFFWith the key FULLY inserted, rotate it COUNTER-CLOCKWISE 1/8th of a turn, so it is about 45 degrees, and with the model on its side, insert the gear into the hole. Turn the key cl