Thingiverse
Valka Kickstarter Replacement Organizer
door vanillasuit
1
Downloads
2
Likes
0
Makes
My copy of Valka came with that dreaded "mold," so I sliced out the organizer part and designed this! I would highly recommend a knife for removing...I tried ripping and it spoiled part of the artwork :(
Note that this most definitely requires glue. The magnets can each be held in by a small piece of duct tape, wrapped from one side around to the other...but I wanted to use some of the KS stickers.
Dividers are optional, but I would recommend at least 3 for quicker access to the storage below the cards.
I didn't like the hard crease in the solo map, so I've made a slot to roll it up.
The dice tray is oversized because I am planning to print the minis and store them there, too.
My cutie patootie snake Macaroni not included!
Note that this most definitely requires glue. The magnets can each be held in by a small piece of duct tape, wrapped from one side around to the other...but I wanted to use some of the KS stickers.
Dividers are optional, but I would recommend at least 3 for quicker access to the storage below the cards.
I didn't like the hard crease in the solo map, so I've made a slot to roll it up.
The dice tray is oversized because I am planning to print the minis and store them there, too.
My cutie patootie snake Macaroni not included!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!