Thingiverse
Value PLA 52mm - 22mm Adapter
von MarcusPfeiffer
0
Downloads
1
Likes
0
Makes
I needed this for my "Value PLA" spools. Every other adapter was either the wrong size or just used way too much material.
This uses 29g of PLA if sliced at 10% infill with no Brim.
There is no need for supports or rafts.
This fits the Anet ET5's factory-issued spool holder, but I'm sure it's appropriate for many others.
This uses 29g of PLA if sliced at 10% infill with no Brim.
There is no need for supports or rafts.
This fits the Anet ET5's factory-issued spool holder, but I'm sure it's appropriate for many others.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
