Thingiverse
Valve Index Controller Charging Station
por Tsinatas
8
Descargas
12
Likes
0
Makes
Valve Index Controller Charging Station
Printed in two parts:
The Base wich houses the cable, an on/off switch and the controllers.
The Backplate, not strictly necessary but saves the controllers from accidentally knocking them over.
If you want some extra stabilty you can just glue the backplate on.
The normal version Base.stl is exactly the version I'm using that perfectly fits my specific magnetic cable, before you print this version check that you have the right cable!
The universal version has larger holes for the cable (11mm) so it should fit every standard USB-C cable.
Print without support at any settings in any filament you like.
I used natural PLA (because that was in the printer at that time) at 0,25mm layers with 15% infill at 100mm/sec (because I'm impatient)
Feel free to share and modify the design.
Printed in two parts:
The Base wich houses the cable, an on/off switch and the controllers.
The Backplate, not strictly necessary but saves the controllers from accidentally knocking them over.
If you want some extra stabilty you can just glue the backplate on.
The normal version Base.stl is exactly the version I'm using that perfectly fits my specific magnetic cable, before you print this version check that you have the right cable!
The universal version has larger holes for the cable (11mm) so it should fit every standard USB-C cable.
Print without support at any settings in any filament you like.
I used natural PLA (because that was in the printer at that time) at 0,25mm layers with 15% infill at 100mm/sec (because I'm impatient)
Feel free to share and modify the design.
Tsinatas también publica en
15 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
