Thingiverse
Valve Index Wall Holder
von rbartl
55
Downloads
21
Likes
1
Makes
Just a little thing to put a Valve Index on a Wall with lenses down.
Probably glue some soft Material on the sides so the valve has it comfy. I used sticky isolation tape. (4mm thick and very soft)
if your printer cannot print 23cm wide objects in one go i split it into 2 pieces.
Probably glue some soft Material on the sides so the valve has it comfy. I used sticky isolation tape. (4mm thick and very soft)
if your printer cannot print 23cm wide objects in one go i split it into 2 pieces.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!