Thingiverse
Valved Air Engine
von Smad
30
Downloads
23
Likes
0
Makes
NOT YET TESTED - Jan 2019
DOESN'T WORK YET BUT LOOKS NICE!
Valve should close by incoming compressed air, if not, will add a valve spring above.
Print 1 of everything and 2 of:
Crank
Crankcase
Hardware Required:
2 off 21 X 12 x 5 Bearing
2 off M8 Washer (Form C)
4 off M6 x 100 CAP HD Bolt
4 of M6 x 35 CAP HD Bolt
DOESN'T WORK YET BUT LOOKS NICE!
Valve should close by incoming compressed air, if not, will add a valve spring above.
Print 1 of everything and 2 of:
Crank
Crankcase
Hardware Required:
2 off 21 X 12 x 5 Bearing
2 off M8 Washer (Form C)
4 off M6 x 100 CAP HD Bolt
4 of M6 x 35 CAP HD Bolt
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
