vannystyle parts

Here are some parts I drew up for the vannystyle frame. I added a few from requests.

1. is a Gopro hero 5-7 mount with or without some lens protectors. it is set at Vannys 22.5*

2. is a DJI OG camera holder. this uses the factory side plates but will hold the lens at the same angle as the Gopro so you don't have to worry about it getting knocked out of alignment since there is only one screw on the factory plates.

3. is a bumper that goes with the camera holder it will slip over the holder, standoffs and bottom plate so you can tighten the standoff screws all the way.

4. my take on arm guards/skids. you print these in TPU and PLA. print the guards in TPU print the skids in PLA. I print the skids with 25% fill but 15 "top" layers that end up being the bottom so you can do lots of skids before you need to print new ones. with this design you tighten the motor screws through only the PLA so you don't have to worry about the TPU squishing out.

5. A XT60 mount that slips