Thingiverse
Vase 9 By CR
von Prenta
17
Downloads
13
Likes
0
Makes
Ok, so now I aimed to test my printers limits and it was again a good drawing exercise.
So became the Vase 9, ABS printed on my Prusa i3.
And where is the warping? Where is the warping!
Even the bottom isn't warped!
BR,
www.3dcr.fi
So became the Vase 9, ABS printed on my Prusa i3.
And where is the warping? Where is the warping!
Even the bottom isn't warped!
BR,
www.3dcr.fi
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
