Thingiverse
Vase Mode "beer" Slug Trap
di AbeFM
32
Download
24
Likes
0
Makes
I tried the tuna-can slug beer trap, and liked it! But watching at night, I noticed most slugs went in, grabbed a six-pack and left. I had the best luck with a can that had an overhang and thought I could print something.
I found a couple great and creative traps here, but they were big (lots of liquid) and took a lot of filament to print. If I'm going to spend $2.50 on a trap I'll let someone else make it for me. :-) These run me about 30 cents if printed in vase mode.
There's a little window because I always overfill and this prevents it. There's a little trough to collect spilled bait and hopefully attract more snails. The steep ridge at the tip is to encourage the slugs to fall.
Let me know your results! If people like it enough I'll make an umbrella and/or a scoop.
CHECK OUT PRINT SETTINGS BELOW
I found a couple great and creative traps here, but they were big (lots of liquid) and took a lot of filament to print. If I'm going to spend $2.50 on a trap I'll let someone else make it for me. :-) These run me about 30 cents if printed in vase mode.
There's a little window because I always overfill and this prevents it. There's a little trough to collect spilled bait and hopefully attract more snails. The steep ridge at the tip is to encourage the slugs to fall.
Let me know your results! If people like it enough I'll make an umbrella and/or a scoop.
CHECK OUT PRINT SETTINGS BELOW
AbeFM pubblica anche su
73 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
