Thingiverse
Vase-mode Component Drawers
door PerspexAvenger
1.3k
Downloads
787
Likes
16
Makes
Looking at all the various options for storage of small items (be it electronic components, bits of Lego, stationery, or whatever), both here and IRL, whilst there's a lot of good solutions, the RL ones are expensive and the printables seem to be overly solid for the task at hand, leading to high filament cost and long prints.
As such, I figured I'd have a play in vase mode and see if I couldn't solve that problem, or at least give people another option, and here it is.
These are models for simple, quick-printing small storage units for 40x80x20mm and 80x80x20mm drawers, going up to ~160mm wide, so you can stick them where you want using Command Strips or tape, and stack them up similarly.
Given spiral printing/vase mode can, occasionally, be (charitably speaking) a little odd, you might have to try a few test prints with small frames before going into production, but I'll add full settings below to hopefully make things more straightforward.
I've printed parts for this success
As such, I figured I'd have a play in vase mode and see if I couldn't solve that problem, or at least give people another option, and here it is.
These are models for simple, quick-printing small storage units for 40x80x20mm and 80x80x20mm drawers, going up to ~160mm wide, so you can stick them where you want using Command Strips or tape, and stack them up similarly.
Given spiral printing/vase mode can, occasionally, be (charitably speaking) a little odd, you might have to try a few test prints with small frames before going into production, but I'll add full settings below to hopefully make things more straightforward.
I've printed parts for this success
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
