Vase (Remix)

I wanted to try "vase-mode" and this was a good looking design so I enlarged it from 120.10mm to 245mm & tried it.
My first print was the tall silver vase with default settings in Cura (0.4mm line width), and it was water-tight but still a bit flimsy.
Next I reprinted it with double the line width at 0.8mm, and it was fantastic, nice, and sturdy. Squeezing the two I cracked the thin vase and broke the top off. I put the top piece into the bottom piece and thought it looked good so I made an .STL file with the shorter version in case others cared to try it. The shorter version is 204.4mm tall.

I used a 0.4mm nozzle, 0.8mm line width, 240º C nozzle, 53º C bed, and 50mm/s speed