Thingiverse
Velcro Cable Connector
door heresathought
0
Downloads
0
Likes
0
Makes
We buy rolls of velcro to perform our cable management.
For cables like AC adaptors, USB cables and any others that use then put away often, i just wanted a simple idea to attach the velcro to the cable so it doesn't get lost while the cable is in use. (Maybe its just me.)
It worked out pretty well. I hope you find it useful.
To assemble:
1) cut the velcro to the desired length
2) loop it around your desired cable.
3) run the loop into the slotted shaft.
4) screw on the nut to hold in place.
Simple to print with nut side on the bed. Not a PnP.
A second roll i bought required i extend the barrel a little bit, I added the fusion 360 file if you need to make any adjustments
For cables like AC adaptors, USB cables and any others that use then put away often, i just wanted a simple idea to attach the velcro to the cable so it doesn't get lost while the cable is in use. (Maybe its just me.)
It worked out pretty well. I hope you find it useful.
To assemble:
1) cut the velcro to the desired length
2) loop it around your desired cable.
3) run the loop into the slotted shaft.
4) screw on the nut to hold in place.
Simple to print with nut side on the bed. Not a PnP.
A second roll i bought required i extend the barrel a little bit, I added the fusion 360 file if you need to make any adjustments
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
