Vent Redirector and Extender

I designed this vent redirector and extender because I was unhappy with the commercial options available for a long extender.

I had to divide it up into 6 sections. I was not happy with the results when I glued them together, likely due to uneven cooling and shrinking. So I designed a friction clip to slide them all together, which works pretty well, though it can be a little tricky with 6 pieces. The curved one was a bit of a challenge in Tinkercad and makes me want to learn something more powerful. There are still some gaps, but not enough to lose a significant amount of air. I designed it so the friction clips can be printed vertically without supports, though the thin contact area probably requires a brim, which I use by default.

With a large format build plate like the Monoprice MP-10 or Ender 5 pro, the redirector and extender could be printed all in one go, greatly simplifying the design an assembly, so I included those as well. I have not printed them, so I can't vouch fo