Thingiverse
VentilaMax
di zmalqp
1
Download
3
Likes
0
Makes
For fun I decided to make a table fan.
The casing is fully 3d printable.
To add weight the base has some space where I poured some concrete.
For the electronics, support for an RS-550 motor is planned.
To control it I used an arduino as a PWM, a mosfet and voltage modulators, but I guess anything is fine.
On the side there are 2 holes to be enlarged as desired for inserting LEDs or potentiometers and on the back there is a support for inserting a 14mm X 13mm current connector.
The casing is fully 3d printable.
To add weight the base has some space where I poured some concrete.
For the electronics, support for an RS-550 motor is planned.
To control it I used an arduino as a PWM, a mosfet and voltage modulators, but I guess anything is fine.
On the side there are 2 holes to be enlarged as desired for inserting LEDs or potentiometers and on the back there is a support for inserting a 14mm X 13mm current connector.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
