Thingiverse
Ventilation kit for Flashforge Creator and Qidi printer
by Robert256
117
Downloads
100
Likes
0
Makes
As my printer is standing in my living room, inhaling the fumes isn't very nice (and probably not healthy). So I created this ventilation kit, using a vacuum hose, which I can hang out of my window. This decreases the fumes to a hardly noticeable level, so I am quite happy with the result.
The files contain
- A 120 mm fan duct with threaded vacuum hose connector
- An endcap for the other end of the vacuum hose to protect it
This is also needed:
- A 120 mm PC fan, USB powered (AliExpress)
- A 120 mm fan filter (from AliExpress, or you can print one)
- A vacuum hose, inner diameter 40 mm, outer diameter 49 mm, thread distance 6 mm (AliExpress)
- Aluminum plate 20 x 30 cm, thickness 1 mm (AliExpress)
Building the ventilation kit is straightforward:
Replace the left side window by the aluminum plate (cut to 24 x 20 cm), in the center of which an 11 cm diameter hole is drilled, and holes for attaching the fan and holes for attaching it to your printer's frame. Put the fan
The files contain
- A 120 mm fan duct with threaded vacuum hose connector
- An endcap for the other end of the vacuum hose to protect it
This is also needed:
- A 120 mm PC fan, USB powered (AliExpress)
- A 120 mm fan filter (from AliExpress, or you can print one)
- A vacuum hose, inner diameter 40 mm, outer diameter 49 mm, thread distance 6 mm (AliExpress)
- Aluminum plate 20 x 30 cm, thickness 1 mm (AliExpress)
Building the ventilation kit is straightforward:
Replace the left side window by the aluminum plate (cut to 24 x 20 cm), in the center of which an 11 cm diameter hole is drilled, and holes for attaching the fan and holes for attaching it to your printer's frame. Put the fan
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
