Vertical Display Stand for Technic Formula 1

I designed this stand because I wanted to display my Technic F1 cars upright on my desk/shelf. This design holds the car at a near 90 degree angle.From my testing it holds well both Mercedes-AMG F1 W14 (Set 42171) and Ferrari SF-24 F1 (Set 42207). Since I don't have the other cars I cannot test if it works on them. How it works: The stand features 3 pins that fit into the open holes of the frame underneath the car (rear engine area). It is designed to fit even if there are existing connector pins inside the frame, as is the case with the Mercedes model. Small note: Since I'm still a bit of a noob in the 3D printing space, I printed this with the default "Extra Draft" settings and it worked well. In my case, the Aux Fan was turned off on my P1S, but I think it can be on without any problem. Hope you find my stand useful.