Thingiverse
Vertical holes calibration
by JPR75
0
Downloads
0
Likes
0
Makes
This is a model with vertical printed holes to calibrate your printer, see the difference between support / no support, etc.
To compare with / without support, in Cura duplicate the model and then use support blocker to forbid support on one of them.
The holes diameters are:
2 mm ; 3 mm ; 5 mm ; 10 mm ; 20 mm ; 30 mm ; 40 mm ; 50 mm
To compare with / without support, in Cura duplicate the model and then use support blocker to forbid support on one of them.
The holes diameters are:
2 mm ; 3 mm ; 5 mm ; 10 mm ; 20 mm ; 30 mm ; 40 mm ; 50 mm
JPR75 also publishes on
29 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
