Vertical Keyboard Holder

Had a total fat kid moment when I realized I couldn't fit a plate on my desk, and since I was too lazy to clean the rest of my desk, I made this! It's a keyboard holder that holds my Redagon keyboard vertical so I can eat chicken nuggies while I watch youtube.

Printing Recommendations:

Infil: 30% Gyroid
Material: 25g (for 2 on the same print) I used PLA+
Time: For 2 at 0.2 layer height: 3hr 5min


This might need minor sanding when it's done but should fit tightly and not need anything else to secure it.