Vertical MKS SBASE case with Full Graphic Smart Controller

This is a vertical case for the MKS SBase Smoothieboard clone, combined with various display cases. Good compact case for printers utilizing aluminum extrusions.

The case bottom is the same for all versions. This forms the back of the case, and holds the MKS SBase board. The others are for the "front" of the case. Depending on the display you are using, you can pick and choose which case "front" works for you.

Accepts M3 screws.

The included spacer is to move the case slightly away from the extrusion so that it does not interfere with Openbuilds wheels. You may or may not need it, depending on your configuration

The second spacer is for cases where the X-axis motor has insufficient clearance to pass the case. This occurred on my Tarantula. It prints without support if rotated 90 degrees and printed on its side.

40 MM low-profile fan recommended.

For the 12864 screen, 4 20mm M3 screws are required to secure the screen cover to the top part of the case.

I