Thingiverse
Vertical Wire Cable Mount
door Japes280
3
Downloads
1
Likes
0
Makes
So my LED visor cable (attached to onboard power supply) was getting a little scary when it nearly got caught on the clip of the hot bed during a big job so...BEHOLD!
I glued this to the power supply cover but there is enough room for screws if you are more committed.
The insert slit is vertical but sideways on the print. Don't worry about support, just snap the block off ;)
I glued this to the power supply cover but there is enough room for screws if you are more committed.
The insert slit is vertical but sideways on the print. Don't worry about support, just snap the block off ;)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
