Vertical X Axis bracket remix

This is just a remix of this excellent design by IamSly to re-site the Ender 5 X axis micro switch to Vertical and operate off the HotEnd Bracket rather than the guide wheels.

here: https://www.thingiverse.com/thing:3609543

I printed off the original and did't feel like bending the micro switch lever as suggested and thus found that the slight touch of the bracket that holds the hot end, twisted the printed bracket on it's screw axis unless really tight.. (tighter than I wanted to go on PLA)

So I measured proper siting of the new design in situ for any overhang of the bracket over the edge of the aluminium rail (which was 1.1mm) and just put a lip on that design of approx 4x4x20mm on the edge in Tinkercad and printed it again. See photos... It is in the perfect place and cannot twist on the bolt head axis anymore.

Since then I bit the bullet and bent the switch lever as much as i dared.

Thanks to the original designer (IamSly) for posting up his design.