Thingiverse
Very Simple 3 Ruler Holder
por iamjaymcquillen
15
Descargas
9
Likes
0
Makes
This is a very simple 3 slot ruler holder. The slots are about 7mm apart, fitting many if not most rulers. For large rulers like pictured (i.e. Quilting rulers) I would print two. One for each end of the rulers. I would recommend an infill of atleast 25%, but you could probably get away with less.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
