VESA Mounts for 3/4" Pipe

Revised 12/31/19

In lieu of tapping the holes for the M3 screws, I have added pockets for M3 Nyloc nuts for the 100 Lite and 200 Vesa mounts. This is a much better solution. As I progress through designing or 3-D printing, I have discovered that tapping is iffy at best and can easily ruin a part. All my designs going forward have incorporated these pockets and are effective.

(8) M3 nuts are less than $2 at Lowes.



VESA mounts for Pretty much any screen out there, if you want to use 3/4" pipe as the base support. Have to tap the holes by hand, do not use a drill, slow and steady and back out every couple of turns to clear chips. Using a drill causes too much heat and will not give you the proper strength.

My kid wanted Red.

Use at your own risk. I did design the structure to support up to 50#, but I do not want to claim responsibility for your TV's/Monitors.

***Edit 4/5/2019*** Uploaded the FreeCad files per request