Thingiverse
Veterinary Hose Clamp
door Giandeau
6
Downloads
27
Likes
0
Makes
This is a hose holder that attaches to the surgery table, for veterinary anesthesia.
I printed it at .2mm, 3 walls, 10% gyroid infill, standard supports, at a 45 degree angle. PETG is recommended, for strength and chemical resistance.
Update: I reinforced the strength of the clip
Update: 2/13/26: Further strengthened the clip section.
I printed it at .2mm, 3 walls, 10% gyroid infill, standard supports, at a 45 degree angle. PETG is recommended, for strength and chemical resistance.
Update: I reinforced the strength of the clip
Update: 2/13/26: Further strengthened the clip section.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
