Thingiverse
VEX Swerve Wheel Bracket
by mgranger114
3
Downloads
5
Likes
0
Makes
*********Update 3/11/23*********
File updated
The holes are offset from the center. This allows it to be used as a swivel wheel without the attached motor. With the holes, hence wheel, in the middle, the bracket won't rotate when the vehicle changes direction (think shopping cart wheel).
*************************************
This is a swerve drive bracket for a VEX robotic project. It has a 60 tooth high strength gear attached to a bracket. The three holes are so a VEX 393 or V5 motor can be attached. The bottom hole is round so you don't have to use a bearing flat.
It goes below a base. A 32 tooth gear can go between two of these with a motor driving the idler gear (32T gear). A Vex 393 with a potentiometer or a V5 motor can control the rotation of the two swerve wheels.
File updated
The holes are offset from the center. This allows it to be used as a swivel wheel without the attached motor. With the holes, hence wheel, in the middle, the bracket won't rotate when the vehicle changes direction (think shopping cart wheel).
*************************************
This is a swerve drive bracket for a VEX robotic project. It has a 60 tooth high strength gear attached to a bracket. The three holes are so a VEX 393 or V5 motor can be attached. The bottom hole is round so you don't have to use a bearing flat.
It goes below a base. A 32 tooth gear can go between two of these with a motor driving the idler gear (32T gear). A Vex 393 with a potentiometer or a V5 motor can control the rotation of the two swerve wheels.
mgranger114 also publishes on
94 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
