Thingiverse
Vexclaw Extender
von Victor2266
2
Downloads
4
Likes
0
Makes
This is an extension for the standard vexclaw, I just attached it to the vexclaw with 3 zipties and mirrored the model in Cura for the right side of the claw.
The holes for the zipties are a bit small and you might want to check if your zipties are too wide. Also the tip of the claw is a bit thin.
The holes for the zipties are a bit small and you might want to check if your zipties are too wide. Also the tip of the claw is a bit thin.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
