Thingiverse
VIC bobbins/replication
por BrraaddK
0
Descargas
0
Likes
0
Makes
The parts here are used to make/replicate Stan Meyer's VIC using 10mm x 100mm MnZn Ferrite rods.
Use supports on brakets and bobbins. Thread a short 4-40 screw into bobbin flange holes and use ring terminals with wire soldered to the terminal for a good connection. With these bobbins and rods you can get a pretty close match to Stan's original VIC.
,BradK
Use supports on brakets and bobbins. Thread a short 4-40 screw into bobbin flange holes and use ring terminals with wire soldered to the terminal for a good connection. With these bobbins and rods you can get a pretty close match to Stan's original VIC.
,BradK
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!