Vicmarc VM100 Chuck Width Template Std Jaws

This is a gauge to ensure that you get a tenon that fits. It is for the Vicmarc VM100 Chuck with standard jaws.
A remix of the chuck jaw width template from PurelyNicole.
I set the max to 56mm and the minimum to 33mm. I have made the minimum a bit conservative as to avoid making the tenon too small and to ensure there's enough stock left to make the tenon conical.
It contains a gauge for a 7º angle. This matches the angleof original jaws for the Vicmarc VM100 (and I believe that 7º is standard angle on inside dovetail on most jaws).

It's nice to have it at hand by the lathe, so it has some areas for small magnets to be glued in.
This also sets it slightly above the surface it's stuck to to make it easier to grab.

I added a name so it's easily distinguishable from the other templates for different jaws and/or chucks, which can be found here:
Vicmarc VM100 with large 3rd party Jaws: https://www.thingiverse.com/thing:2672684
Supernova with standard jaws: https://www.thingiver